- Print
- DarkLight
- PDF
Configure a SiteManager with an USB stick
Article Summary
Share feedback
Thanks for sharing your feedback!
This article provides information on how to set up a SiteManager XX29, XX39 and XX49.
- A SiteManager unit.
- A Windows PC that can access the GateManager that is going to be used.
- A USB key to save the configuration file on.
Basic Questions
What is a SiteManager ?
SiteManager is the hardware (or software) that you place in your remote location where you want to gain access to a device. Its easy to set up, easy to use, and easy to configure both remotely and locally.
What are the power requirements of SiteManager?
SiteManager must be fed 12 - 24V DC. Power should be applied to the GND and +terminals, only because it is also recommended to connect the earth ground in order to reduce interference of noise.
The official power voltage tolerance for SiteManager is 5% tolerance (25.2V).
Basic setup and usage
Initial setup guide
- Log in to GateManager and press the domain you wish SiteManager to be part of.
- On the right-hand side click the USB icon next to the "Create USB Configuration:" field.
- GateManager will open the window seen below - fill out the "Appliance Name:" - you can also fill out the other fields if you already know what they are going to be.
- Click the "Create" button - and save the file - after that copy it to the root of your USB stick.
- Power on SiteManager and wait for "POWER" to have a permanent green light and "STATUS" to have a permanent red light or flashes red twice.
- Insert the USB stick into one of the USB slots and wait for the "STATUS" LED to start flashing, then remove the USB stick.
- When both the "POWER" and "STATUS" have a green light your SiteManager is ready to be used.
- It will show up in GateManager with the Appliance Name you gave it and have a green checkmark.
- SiteManager is now ready to be used.
Was this article helpful?